89.90ريال سعودي
-
أقل سعر
89.9 -
أعلى سعر
89.9 -
آخر ارتفاع في السعر
0%
89.90ريال سعودي
This projector mount is compatible with most projectors on the market including BenQ, ViewSonic, Epson, Optima, Asus, and Acer ect.
Height Adjustment (ceiling): 5 - 25.6
Wall Extension: 16.9 - 25.6
Pitch: +/- 15°
Roll: +/- 8°
Weight Capacity: 44 lbs
Material: Steel
Installation Guide:
Step 1: Use the mounting plate with the expansion bolts to mark a position you want to install the projector.
Step 2: Use the M5 screws to screw the mounting plate with the extension arm. The extension arm is stretchable, you can adjust it to a proper length by losing the screw on it.
Step 3: Insert the Pan & tilt the swivel into the bracket and fixed them with M5 screws, tighten all the screws with your screwdriver.
Step 4: Use the M5 screws to connect the extension arm with the bracket, align the holes, fix them with the M5 screws, and then tighten them with your screwdriver.
Step 5: Connect the finished bracket with the projector. Needs to use M4 screws(Some projector fits the M3 screws) and the screw washer. The Bracket is expendable and stretchable, align the holes on the long plates with the mounting holes on the projector top to check if they fit each other. If the bracket doesn't fit the holes, you can use the 2 small plates to do the trick. (Lose the nuts on the long plates and took them out, use the M4 screw to fix the small plate according to the holes on the projector. Insert the small plate into the bracket, and screw the nuts a little bit). Adjust the angle of the bracket as needed, then insert another two screws into the projector. Tighten all the screws with your screwdriver, and then tighten the nuts.